D:SP EDITOR - (For models with RS-485 connection)
Allows you to connect the speakers to a computer using an RS-485 interface – allowing you to change EQ and other parameters. You can also view levels and check the status and the "health" of each speaker.
|Equalizer||Full Parametric 6 bands - Boost/Cut = +/- 12 dB - Q factor = 0.4/20|
|Noise||Dynamic - Mode = Soft/Normal/Hard|
|MultiComp||3-band Multiband Compressor - Mode = Soft (1:2)/Normal(1:6)/Hard(1:20) - Threshold = 0/-12dB|
|Delay||Delay line up to 250 meters (720 ms)|
|Volume||Adjust the incoming signal level in the range -48/0db|
|Metro||Double LED scale used to monitor the signal level on high and low frequencies|
|Mode||Solo, Mute, Link, Group|
|State||ID, Name, Model, Group, Solo, Mute, Temp, Prot, Status|
PC EDITOR - (for models equipped with RS-485)
To easily customize every parameter of your loudspeakers a PC editor program is available. This allows you to connect and monitor the speakers – from editing equalizers and parameters, to displaying levels, even checking the status and “health” of every connected loudspeaker - showing real time temperature, signal overloads, limiter activities and other status information of the D:SIDER.
REMOTE CONTROL RS-485
In addition to the DSP functionalities, directly accessible on the speaker, you can gain greater control of the D:SIDER speaker by using an RS-485 remote control interface and a personal computer. An optional USB-485 interface (D:SP INTERFACE) and the personal computer software (D:SP EDITOR) are available. This makes it possible to control a large number of parameters within the signal processing and to monitor in real time important aspects of the speakers. With just a single USB-485 you can daisy-chain up to 127 different speakers!